P/N: 4PFX020-010
©2004 Paxton Automotive Corp.
All Rights Reserved, Intl. Copr. Secured
28JUL04 v1.2(Univ.SBF Carb-4PFX v1.2)
10.1 FINAL REASSEMBLY AND CHECK
10-1
A. Reconnect the battery.
B. If your vehicle has gone over 15,000 miles
since its last spark plug change, you will need
to change the spark plugs now before test
driving the vehicle.
C. Check all fittings, nuts, bolts and clamps for
tightness. Pay particular attention to oil and
fuel lines around moving parts, sharp edges
and exhaust system parts. Make sure all wires
and lines are properly secured with clamps or
tie wraps.
D. Check all fluid levels, making sure that your
tank(s) is filled with 91 octane or higher fuel
before commencing test drive.
E. Start engine and allow to idle a few minutes,
then shut off.
F. Recheck to be sure that no hoses, wires, etc.
are near exhaust headers or moving parts and
for signs of any fluid leakage. Re-jet the
carburetor as required. Install a boost refer-
enced high-performance mechanical fuel
pump or high performance electric fuel pump
with boost referenced fuel regulator. Check
ignition timing to make sure it is properly set
before commencing test drive.
G. PLEASE TAKE SPECIAL NOTE: Operat-
ing the vehicle without all sub assemblies
completely and properly installed and working
may cause FAILURE OF MAJOR ENGINE
COMPONENTS.
H. Keep in mind that this manual does not
address air/fuel or ignition timing consider-
ations. (See Page iv.)
I. Test drive the vehicle.
J. Read the STREET SUPERCHARGER
SYSTEM OWNER'S MANUAL AND
RETURN THE WARRANTY REGISTRA-
TION FORM within thirty (30) days of
purchasing your supercharger system to
qualify.
*** WARNING ***
Do not attempt to operate the vehicle until ALL
components are installed and ALL operations
are completed including final check.
Section 10
FINAL RE-ASSEMBLY AND CHECK
Fig. 10-a / Passenger side installation. (64-68 Mustang)
Fig. 10-b / Driver side installation. (64-68 Mustang)
