P/N: 4PFX020-010
©2004 Paxton Automotive Corp.
All Rights Reserved, Intl. Copr. Secured
28JUL04 v1.2(Univ.SBF Carb-4PFX v1.2)
A. The supercharger uses engine oil for lubrica-
tion and must have an oil feed line connected
to a filtered oil access on the engine.
B. Remove the 1/4" NPT oil pressure sending
unit from the fitting installed in the engine
block (just above the factory fuel pump).
Install the supplied 1/4 NPT street TEE in the
factory fitting. Install the oil pressure sender in
one of the openings and the supplied 1/4 NPT
x -4 fitting in the other. (See Fig. 3-a).
*** NOTE ***
Use clean engine oil on the pipe threads. Teflon
tape and sealant is NOT recommended as it might
loosen and cause blockage of the small oil feed
orifice resulting in supercharger failure.
C. Attach the 90° end of the supplied -4 braided
oil feed line to the installed fitting. (See Fig.
3-a). Secure the hose with the tie wraps
provided, routing it away from exhaust heat,
chafing and/or sharp objects. Temporarily
cover the open end from debris until the
connection is made to the supercharger.
3.1 OIL FEED INSTALLATION
Fig. 3-a
Section 3
OIL FEED INSTALLATION
3-1
