A SERVICE OF

logo

Open as PDF
next previous
8
STEP 8:
FIGURE 8
STEP 9:
FIGURE 9
• LOOSELY assemble the TOP BOOM (1) to the UPRIGHT FRAME (2) using one 1/2 X 2-1/2” BOLTS (34), one 1/2 X 3” BOLT (35),
two 1/2” WASHERS (43), and one 1/2” LOCK NUT (44) as shown in FIGURE 8.
• Insert one 3 X 2” END CAP (19) into the end of the TOP BOOM (1). See FIGURE 8.
• Slide two VINYL CAPS (27) over the LAT BAR SUPPORT (8) as shown in FIGURE 9.
• SECURELY assemble the LAT BAR SUPPORT (8) to the TOP BOOM (1) using one 3/8 X 2-3/4” (32) and one 3/8” LOW HEIGHT LOCK
NUT (41). See FIGURE 9.
33 3/8 X 4”
32 3/8 X 2-3/4”
1/2 X 2-1/2” 34
1
44
43
40
42
19
32 3/8 X 2-3/4”
3/8” LOW HEIGHT 41
27
1
8
42
* SECURELY TIGHTEN ALL LOOSE CONNECTIONS MADE UP TO THIS POINT!
5
7
2
• LOOSELY assemble the TOP BOOM (1) to the UPPER CROSS SUPPORT (7) using two 3/8 X 4” BOLTS (33), four 3/8” WASHERS
(40) and two 3/8” LOCK NUTS (42). See FIGURE 8.
• LOOSELY assemble the TOP BOOM (1) to the UPRIGHT FRAME (2) using one 3/8 X 2-3/4” BOLTS (32) and one 3/8” LOCK NUT
(42) as shown in FIGURE 8.
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
35 1/2 X 3”