A SERVICE OF

logo

Open as PDF
next previous
12
FIGURE 14
STEP 14:
FIGURE 15
STEP 15:
• SECURELY assemble the CABLE (18) to the plate on the UPRIGHT FRAME (2) using one 3/8 X 1-1/4” BOLT (30), two 3/8” WASHERS
(40), and one 3/8” LOCK NUT (42). See FIGURE 14.
30 3/8 X 1-1/4”
40
42
2
18
• SECURELY assemble the SPRING PIN ASSEMBLY (45) to the KNEE SUPPORT (3) as shown in FIGURE 15.
• SECURELY assemble the KNEE SUPPORT (3) to the UPRIGHT FRAME (2) using one 1/2 X 5-1/2” BOLT (38) and one 1/2” LOCK
NUT (44). (NOTE: Do not overtighten this connection, the KNEE SUPPORT should rotate freely.) See FIGURE 15.
• Assemble two 4 X 7” ROLLER PADS (15) to the KNEE SUPPORT (3) using two STARLOCK COLLARS (46) as shown in FIGURE 15.
3
2
45
38 1/2 X 5-1/2”
44
15
46
0
1
2
345
6
1/2 1/2 1/2 1/2 1/2 1/2
• SECURELY tighten the bolts of the PULLEY BLOCK
• Attach one 1” SQ. GLIDE (21) to the UPRIGHT FRAME (2) where the round of the KNEE SUPPORT (3) makes contact.
ROUND
21