ParaBody 841101 Manual

next previous

STEP 5:

¯ Insert four CAP PLUGS (21) into the bottom end & top end of the two GUIDE RODS (9) as shown in FIGURE

Securely assemble the WEIGHT STACK SHAFT (13) to the HEAD PLATE (14) using one 3/8 X 1-1/4" BOLT (23) and one

WASHER (31).

Insert two GUIDE RODS (9) into the WEIGHT STACK BASE (7) as shown on FIGURE 5. (NOTE: Lubricate GUIDE

(9) with silicon or teflon spray available at most hardware stores.)

¯ Slide two WEIGHT STACK CUSHIONS (19) down over the GUIDE RODS (9).

Using EXTREME CARE slide all twenty WEIGHT PLATES (43) down over the GUIDE RODS (9) on to the WEIGHT STACK

CUSHIONS (19). Make sure that the keyholes of the WEIGHT PLATES (43) are all facing the right

CAREFULLY slide the HEAD PLATE ASSEMBLY down over the GUIDE RODS (9) onto the WEIGHT STACK.

Attach the WEIGHT STACK LABELS (10) to the WEIGHT STACK. Also insert the WEIGHT STACK SELECTOR PIN (39)

the fn’st WEIGHT PLATE (43) of the WEIGHT STACK.