LG - Life's Good STB-3000 Manual

A SERVICE OF

next previous

47

206-4272

Cloning Procedures (Cont.)

(Continued from previous page)

9. When you are ready to initiate the Teaching process, select UPDATE on the screen and then

press OK on the Installer Remote.

CANCEL

BACK

UPDATE

Channel Tuning / Channel Banner Display

Logical

Physical

TEACH TO STB (TLX)

STB MANAGER

Select USB Memory Device

ˇ

USB Device 1:

Device Name

Select the ﬁle to download, and then select UPDATE below.

STB-3000-UA00001.TLX

Teaching status will be shown in a pop-up progress banner at the bottom of the Teach To

STB (TLX) screen. This process may take a few minutes. Do NOT remove the USB device

until Teaching is complete. When the Teaching process is complete, an “Updating completed”

messageisbrieydisplayed,andtheSTBManager/USBDownloadMenuisexited(see

also note below).

Note: If you updated the STB configuration with a TLX file that included a change to Installer

Menu item 105 VID OUT FORMAT, once Teaching is completed, a Changing Screen Resolution

banner will be displayed, and the STB will reboot within a few seconds to change the resolution

peryourselection.Thenewscreenresolutionwillalsorequireuserconrmationafterreboot.

See item 105 description on page 37 for further information.

10. Remove the USB memory device from the Target STB, and verify that the appropriate

congurationisnowresidentontheTargetSTB.

Note: IftheTargetSTBwaspreviouslyinPass-throughMode,andtheTLXleusedforTeaching

contained an FTG Channel Map, the Target STB CPU is now in FTG Mode. After the Teaching

process (and,ifapplicable,anSTBreboot/conrmationofnewscreenresolution)is complete,

the STB tunes according to the Start Channel setting in the Installer Menu. If a Start Channel is

specied,theSTBwilltunetothatchannel,though,inthecaseofFTGModeconguration,a

channel banner will only be displayed if the Start Channel is included in the FTG Channel Map

(depending on your selection in step 8, the channel banner will display either the Start Channel’s

logical channel number or physical RF channel number). Otherwise, the STB will either return to

the last channel tuned (STBinPass-throughMode)ortunetotherstchannelintheFTGChannel

Map (STB in FTG Mode). If the latter, remember that the channels in the FTG Channel Map are

always arranged in logical order, regardless of your selection in step 8.