Enterasys Networks 4H4283-49 Manual

A SERVICE OF

next previous

Connecting to COM Port for Local Management

Matrix DFE-Gold Series Modules Hardware Installation Guide 3-21

WithaUTPstraight‐throughcableandRJ45‐to‐DB25femaleadapter,youcanconnect

productsequippedwithanRJ45COMporttoaVTseriesterminalorVTtypeterminals

runningemulationprogramsfortheVTseries.

WithaUTPstraight‐throughcableandanRJ45‐to‐DB25maleadapter,

youcanconnect

productsequippedwithanRJ45COMporttoaHayescompatiblemodemthatsupports

9600 baud.

Connecting to an IBM PC or Compatible Device

ToconnectanIBMPCorcompatibledevice,runningtheVTterminalemulation,toan

Enterasys NetworksmoduleCOMport(Figure 3‐12),proceedasfollows:

1. ConnecttheRJ45connectoratoneendofaUTPstraight‐throughcabletothe

communicationsCOMportontheEnterasys Networksmodule.(TheCOMportis

alsoknownasaConsoleport.)

2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐throughcableintoan

RJ45‐to‐DB9adapter.

3. ConnecttheRJ45‐to‐DB9adaptertothecommunicationsportontheIBMPC.

4. TurnonthePCandconfigureyourVTemulationpackagewiththe

following

parameters:

5. Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.

RefertotheappropriateEnterasysMatrixDFE‐GoldSeriesConfigurationGuidefor

furtherinformation.

Parameter Setting

Mode 7 Bit Control

Transmit Transmit=9600

Bits Parity 8 Bits, No Parity

Stop Bit 1 Stop Bit