32-41
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
78-17058-01
Chapter 32 Configuring IP Unicast Routing
Configuring BGP
BGP confederation identifier/peers • Identifier: None configured.
• Peers: None identified.
BGP Fast external fallover Enabled.
BGP local preference 100. The range is 0 to 4294967295 with the higher value preferred.
BGP network None specified; no backdoor route advertised.
BGP route dampening Disabled by default. When enabled:
• Half-life is 15 minutes.
• Re-use is 750 (10-second increments).
• Suppress is 2000 (10-second increments).
• Max-suppress-time is 4 times half-life; 60 minutes.
BGP router ID The IP address of a loopback interface if one is configured or the highest IP address
configured for a physical interface on the router.
Default information originate
(protocol or network redistribution)
Disabled.
Default metric Built-in, automatic metric translations.
Distance
• External route administrative distance: 20 (acceptable values are from 1 to 255).
• Internal route administrative distance: 200 (acceptable values are from 1 to 255).
• Local route administrative distance: 200 (acceptable values are from 1 to 255).
Distribute list
• In (filter networks received in updates): Disabled.
• Out (suppress networks from being advertised in updates): Disabled.
Internal route redistribution Disabled.
IP prefix list None defined.
Multi exit discriminator (MED)
• Always compare: Disabled. Does not compare MEDs for paths from neighbors in
different autonomous systems.
• Best path compare: Disabled.
• MED missing as worst path: Disabled.
• Deterministic MED comparison is disabled.
Table 32-9 Default BGP Configuration (continued)
Feature Default Setting