38-101
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 38 Configuring IP Unicast Routing
Monitoring and Maintaining the IP Network
Monitoring and Maintaining the IP Network
You can remove all contents of a particular cache, table, or database. You can also display specific
statistics. Use the privileged EXEC commands in Table 38-16 to clear routes or display status:
Table 38-16 Commands to Clear IP Routes or Display Route Status
Command Purpose
clear ip route {network [mask | *]} Clear one or more routes from the IP routing table.
show ip protocols Display the parameters and state of the active routing protocol
process.
show ip route [address [mask] [longer-prefixes]] |
[protocol [process-id]]
Display the state of the routing table.
show ip route summary Display the state of the routing table in summary form.
show ip route supernets-only Display supernets.
show ip cache Display the routing table used to switch IP traffic.
show route-map [map-name] Display all configured route maps or only the one specified.
