38-92
Cisco Catalyst Switch Module 3110 and 3012 for IBM BladeCenter Software Configuration Guide
OL-12189-01
Chapter 38 Configuring IP Unicast Routing
Configuring Protocol-Independent Features
To delete an entry, use the no route-map map tag global configuration command or the no match or no
set route-map configuration commands.
You can distribute routes from one routing domain into another and control route distribution.
Beginning in privileged EXEC mode, follow these steps to control route redistribution. Note that the
keywords are the same as defined in the previous procedure.
Step 18
set metric bandwidth delay reliability loading mtu Set the metric value to give the redistributed routes (only
for EIGRP) only on a Catalyst Switch Module 3110:
• bandwidth—Metric value or IGRP bandwidth of the
route in Kb/s in the range 0 to 4294967295
• delay—Route delay in tens of microseconds in the
range 0 to 4294967295.
• reliability—Likelihood of successful packet
transmission expressed as a number between 0 and
255, where 255 means 100 percent reliability, and 0
means no reliability.
• loading— Effective bandwidth of the route expressed
as a number from 0 to 255 (255 is 100 percent
loading).
• mtu—Minimum maximum transmission unit (MTU)
size of the route in bytes in the range 0 to
4294967295.
Step 19
set metric-type {type-1 | type-2} Set the OSPF external metric type for redistributed routes
only on a Catalyst Switch Module 3110.
Step 20
set metric-type internal Set the multi-exit discriminator (MED) value on prefixes
advertised to an external BGP neighbor to match the IGP
metric of the next hop only on a Catalyst Switch
Module 3110.
Step 21
set weight Set the BGP weight for the routing table only on a
Catalyst Switch Module 3110. The value is from 1 to
65535.
Step 22
end Return to privileged EXEC mode.
Step 23
show route-map Display all configured route maps or only the one
specified to verify configuration.
Step 24
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
router {bgp | rip | ospf | eigrp} Enter router configuration mode.
A switch running the IP base feature set (for example,
the Catalyst Switch Module 3012) supports only the
rip keyword.
