6
Instruction Manual PSB-1401
DETERMINE MOUNTING BRACKET HOLE PATTERN
Each interface bracket has 4 square holes for attaching mount-
ing buttons (See Figure 2). The square holes in the brackets are
arranged in a 14” vertical spacing pattern.
When the proper hole pattern is used, the mounting buttons
form a 14” square (horizontal and vertical) pattern when
installed on your Large Flat Panel display.
The hole patern for the interface brackets are divided into two
group sets:
• “Groups 1 Through 11 Hole Pattern” on page 6
• “Groups 12 Through 16 Hole Pattern” on page 7
Select the appropriate group for the instructions that explain
how to attach the mounting buttons in the proper square holes
for your specific Flat Panel Display model.
Groups 1 Through 11 Hole Pattern
WARNING:Failure to use proper attaching hardware and
installation procedures may result in equip-
ment damage or serious personal injury.
1. Lay the brackets out with the bent lip of each interface
bracket down (see Figure 2).
2. Open parts bag A.
3. Using the mounting buttons and hardware in parts bag A,
attach the mounting buttons in the square holes closest to
the middle (inside) of each interface bracket (see
Figure 2 and Figure 3).
4. Using the group number you recorded for your Large Flat
Panel display model, proceed to the applicable page in this
manual and follow the instructions for your Flat Panel Dis-
play model.
Item Description Qty.
Bracket Left 1
Bracket Right 1
Parts Bag A
10-24 x 7/8” Button Head Cap Screw 4
10-24 Ny-Lock Nut 4
Mounting Button 4
1/8” Allen Key 1
Bent Lip Down
Bent Lip Down
Figure 3. Button Installation for Groups 1-11
Figure 2. Brackets for Groups 1-11 with Bent Lip Down
