10
Instruction Manual PSB-1401
Group 3 Installation Procedures
WARNING:Failure to use proper attaching hardware and
installation procedures may result in equip-
ment damage or serious personal injury.
Attach Interface Brackets
1. Identify parts bags B, H, and J.
2. Remove the Nylon spacers from the parts bag labeled B.
3. Place the Nylon spacers over the six mounting holes on
your Large Flat Panel display (see Figure 11).
4. Place the interface brackets over the Nylon spacers (see
Figure 12 and Figure 13).
5. Select parts bags H and J.
CAUTION: Overtightening mounting screws may damage
your Large Flat Panel display.
6. Using the hardware in parts bags H and J, place one steel
flat washer over the interface bracket (see Figure 12 and
Figure 13) and secure the interface brackets to your Large
Flat Panel display using the M6x20mm screws. Do not
overtighten the mounting screws.
Item Description Qty.
Bracket Left 1
Bracket Right 1
Parts Bag B Nylon Spacer .75” OD x .26” ID x .375” 12
Parts Bag H M6 x 20mm Phillips Head Cap Screw 6
Parts Bag J 1/4” Steel Washer 6
Figure 11. Spacer Location for Group 3
Figure 12. Spacer Installation for Group 3
Figure 13. Bracket Attachment for Group 3
