Filter
Top Products
FR587W-INS-LAB-RevC13: Deluxe Extra-Wide Clinical Care Recliner Assembly and Operating Instructions
16
9. Insert the Y-cable connector labeled UPPER into the back cushion
cable connector also labeled UPPER until its locking tabs snap into
place, as shown at right.
10. Insert the Y-cable connector labeled LOWER into the back cushion
cable connector also labeled LOWER until its locking tabs snap into
place, as shown at right.
11. Insert the Y-cable connector labeled MASSAGE into the control
module connector also labeled MASSAGE (see picture of control
module at top of previous page) until its locking tab snaps into
place.
12. Insert the seat cushion cable connector labeled HEAT A into the
back cushion cable connector also labeled HEAT A until its locking
tabs snap into place, as shown at right.
13. Insert the cable connector labeled HEAT into the control module
connector also labeled HEAT (see picture of control module at top of previous page)
until its locking tab snaps into place.
14. Place the cable labeled HEAT A inside the junction box. Replace the junction box cover;
replace the two hex head screws that secure the junction box cover (see picture of
junction box at top of previous page). Use a
1
/4" hex wrench to secure the screws.
15. Gather loose cable sections and secure them with the plastic cable ties furnished (see
picture of junction box at top of previous page).
16. With assistance, carefully return the recliner to its upright position.
17. Reinstall the left side table with the ball lock pin.
18. The Heat and Massage Unit is now ready for operation. Instructions for use follow.
s
Heat and Massage Unit Operation Instructions
1. Plug the power supply cord into any grounded outlet.
2. The Heat and Massage Unit is operated
using the single multi-position selector
switch located on the right side of the
recliner underneath the armrest. The
Heat and Massage Functions can be
operated independently. The selector
switch faceplate is shown at right.
3. Press the selector switch UP to activate
the HEAT FUNCTION.
4. Press the selector switch DOWN to
activate the MASSAGE FUNCTION.
Connect Upper
and Lower Cables
Connect HEAT A
Cables