Filter
Top Products
2
Battery Installation
Battery installation should take place before attaching the SST to a valve. If you have
already attached the SST to a valve, you will need to detach it.
1. Place the SST face down. e battery
compartment is sealed with four (4) screws.
2. Unscrew all screws and remove the battery
compartment lid using a Phillips screw driver.
3. Install one 9-volt battery (not included).
Observe the polarity of the picture.
4. Reattach the lid and screws, ensuring the
rubber sealing gasket is in place.
e battery should be replaced as part of
yearly maintenance. e controller will
maintain time/day/program for 32 minutes
without a battery installed.
9V