Filter
Top Products
11
Installing a Rain Sensor
It is possible to connect a wired Toro® RainSensor™ to the SST. Other normally closed
sensors can be installed as well. Wired polarity is not observed for the sensor.
1. Cut the wire loop (yellow) from the SST.
(See Figure 1.)
2. Strip 1/2˝ (1.25 cm) of insulation from the
wires. Connect the SST wires to the rain
sensor wires using water-sealed / proof wire
connectors (not included).
(See Figure 2.)
2
2
1
1
yellow wire