Filter
Top Products
EPX10 User Manual ◄ 23
REPLACING THE BATTERY
Econect battery kit P/N-73720 for serial number
1215091 and Higher.
Including:
Econect battery.
2 x 13mm spanner.
3mm hexagon key.
Side cutters.
Resistor 22Ohm/4W.
2 x Plastic washer.
3 x Cable ties.
The Battery kit (P/N-73720) and steps 1 thru 19 listed below applies only
to units with S/N 1215091 and Higher. For Units with serial number 1215090 & below,
these units must be returned to the factory for battery replacement.
1. Remove all screws on the sides of the unit
with a 3mm hexagon key.
2. Cut the cable ties for the positive and fan cable.
3. Pull out the connector for the fan.