Filter
Top Products
STORAGE
To store the 0890 Air Bike simply keep it in a clean dry place.
The 0890 Air Bike is 47" long x 25" wide x 46" tall.
The 0890 Air Bike must be lifted for movement. Two people may be required.
To avoid damage to the electronics, remove the batteries before storing the 0890 Air Bike for one year
or more.
1.
2.
3.
4.
MAINTENANCE
The safety and integrity designed into the 0890 Air Bike can only be maintained when the 0890 Air Bike is
regularly examined for damage and wear. Special attention should be given to the following:
Verify that the Locking Pins(40) are properly installed and the spring loaded ball near the end of pin will
keep each Locking Pin in place.
Adjust the Tension Knob(30) and verify that the Tension Belt(28) provides tension. The Tension Belt(28)
should provide many years of use.
Verify that the Thin Nuts(41) are properly tightened to prevent the pedals from coming loose.
Verify that the Warning Label(81) is in place and easy to read. Call Stamina Products immediately
(1-800-375-7520) for a replacement Warning Label if the Warning Label is missing or damaged.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the 0890 Air Bike removed from service
until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the 0890 Air Bike.
Keep your 0890 Air Bike clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.
8.
TROUBLE SHOOTING GUIDE
IT IS NOT NECESSARY TO RETURN ENTIRE BIKE FOR A MONITOR REPAIR.
THE MONITOR IS REMOVABLE FROM BIKE FOR REPAIR OR REPLACEMENT.
PROBLEM CORRECTION
Replace Batteries. (Use Two
AA.)
NOTE: Odometer Will Be Reset
After Replacing Batteries. See
Page 13.
Securely Plug Pickup Wire Into
Back Of Monitor.
Replace Speed Pickup.
Replace Monitor.
Adjust Chain - See Page 11
Chain Adjustment.
1.
1.
2.
3.
1.
CAUSE
Batteries Weak Or Dead.1.
Pickup Wire Not Connected To
Monitor.
1.
Speed Pickup Not Working
Properly.
2.
Monitor Not Working Properly.3.
Chain Is Too Loose.1.
No Display On Monitor.1.
No Speed Or Distance Displays
On Monitor.
2.
Chain Makes Popping Noise.3.
1. 1.
4. Adjust ChainChain is too loose and hits fan.Bike makes sudden loud noise.
Fan needs adjustment.1.Resistance too high.6. Adjust fan per instructions on
page 11 and 12.
1.
Bike Is Not Level.1.Bike Rocks As You Pedal. Adjust Leveling Caps On Rear
Stabilizer Until Bike Is Level.
1.
5.
10