Filter
Top Products
a
= OPERATION OF CONTROL PANEL (R-2S58)
The operation of the oven is controlled by pressing the appropriate pads arranged on the surface of the
control panel.
An entry signal tone should be heard each time you press the control panel to make a correct entry.
In addition the oven wil! beep for approximately 2 seconds at the end of the cooking cycle, or 4 times
when a cooking procedure is required.
Plug the oven into a power point and
1
switch on the power.
I I
I
Flashing eights
121
Close the oven door.
as above
Press the STOP/CLEAR pad so that the
3
oven beeps.
cl
Onlythedotswill remain.
* To enter the present time of day 1 I:34 (AM or PM).
Press the POWER LEVELOSERVE pad
1
for 3 seconds.
I
Enter the correct time of day (hours) by
2
pressing TIME pads.
(z)(z) ::
3
Press the POWER LEVEL@ /SERVE pad
again.
POWER
I I
LEVEL 0
SERVE
I I nn
1 1 uu
Enter the correct time of day (minutes)
-r
4
by pressing TIME pads.
I i
x3 x4j -
Press the POWER LEVELOSERVE pad
again.
POWER
I I
LEVEL 0
SERVE
I I’
I I*
34
Use the STOP/CLEAR pad to:
1. Stop the oven temporarily during cooking.
2. Clear if you make a mistake during programming.
Press the STOP/CLEAR pad twice.
6