Filter
Top Products
05/3/8 CD-SW200EA 31-40 .fm
36
CD-SW200E
Advanced Features
Enhancing your system (continued)
Headphones
Before plugging in or unplugging the headphones, reduce the vol-
ume.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and
impedance between 16 and 50 ohms. The recommended imped-
ance is 32 ohms.
Plugging in the headphones disconnects the speakers automati-
cally. Adjust the volume using the VOLUME control.
Troubleshooting chart
Many potential problems can be resolved by the owner without call-
ing a service technician.
If something is wrong with this product, check the following before
calling your authorised SHARP dealer or service centre.
General
CD player
CD-SW200
Symptom Possible cause
The clock is not set to the
correct time.
Did a power failure occur? Reset
the clock. (Refer to page 14.)
When a button is pressed,
the unit does not respond.
Set the unit to the power stand-
by mode and then turn it back on.
If the unit still malfunctions, reset
it. (Refer to page 38.)
No sound is heard.
Is the volume level set to "0"?
Are the headphones connected?
Are the speaker wires discon-
nected?
Symptom Possible cause
Playback does not start.
Is the disc loaded upside down?
Playback stops in the mid-
dle or is not performed
properly.
Does the disc satisfy the stan-
dards?
Is the disc distorted or
scratched?
Playback sounds are
skipped, or stopped in the
middle of a track.
Is the unit located near excessive
vibrations?
Is the disc very dirty?
Has condensation formed inside
the unit?