Filter
Top Products
05/3/8 CD-SW200EA 23- 30.fm
30
CD-SW200E
Tape Recording
Recording on a cassette tape (continued)
Recording from several CDs continuously:
To perform programmed recording:
To stop recording:
Press the (TAPE ) button.
The disc and tape will stop.
Recording from the radio
To interrupt recording:
Press the button.
To resume recording, press the / (TAPE ) button.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise whilst recording an AM station, move the
AM loop aerial.
Dubbing from tape to tape
You can record from TAPE 1 to TAPE 2.
To stop dubbing:
Press the (TAPE ) button.
TAPE 1 and TAPE 2 will stop simultaneously.
Erasing recorded tapes
Note:
Make sure that the TAPE 1 is not in use.
1 Perform steps 1 - 5 in "Recording from a CD or MP3/WMA disc"
on page 29.
2 Within 5 seconds, press the / (TAPE ) button to start record-
ing.
1 Programme discs and tracks (see page 20).
2 Press the button.
3 Press the / (TAPE ) button to start recording.
1 Tune in to the desired station (see page 25).
2 Load a cassette into the TAPE 2 cassette compartment
with the side to be recorded on facing you.
Wind past the leader of the tape, on which recording cannot be
performed.
3 Press the button.
Recording will be paused.
4 Press the / (TAPE ) button to start recording.
1 Press the ON/STAND-BY button to turn the power on.
2 Load a prerecorded cassette
into the TAPE 1 cassette com-
partment. Insert a blank tape
into the TAPE 2 cassette com-
partment.
It is recommended that the recording tape is the same length as
the master tape.
3 Press the TAPE (1 2) button until "TAPE 1" appears on
the display.
4 Press the button.
Recording will be paused.
5 Press the / (TAPE ) button to start dubbing.
1 Load the tape to be erased into the TAPE 2 cassette compart-
ment with the side to be erased facing towards you.
2 Press the TAPE (1 2) button until "TAPE 2" appears on the dis-
play.
3 Press the button.
4 Press the / (TAPE ) button to start erasing.
TAPE 1 TAPE 2