Filter
Top Products
17/03/05 CD-SW200EA 02-12.fm
10
CD-SW200E
Preparation for Use
System connections (continued)
Aerial connection
Supplied FM aerial:
Connect the FM aerial wire to the FM 75 OHMS terminal and position
the FM aerial wire in the direction where the strongest signal can be
received.
Supplied AM loop aerial:
Connect the AM loop aerial to the AM LOOP socket. Position the AM
loop aerial for optimum reception. Place the AM loop aerial on a
shelf, etc., or attach it to a stand or a wall with screws (not supplied).
Note:
Placing the aerial on the unit or near the AC power lead may cause
noise pickup. Place the aerial away from the unit for better reception.
Installing the AM loop aerial:
Speaker connection
FRONT SPEAKERS:
Connect the black wire to the FRONT SPEAKERS minus (-) terminal,
and the red wire to the FRONT SPEAKERS plus (+) terminal.
SUBWOOFER:
1. Connect the black wire to the SUBWOOFER minus (-) terminal,
and the red wire with purple insulation tube to the SUBWOOFER
plus (+) terminal.
2. Connect the subwoofer light-up wire to the SUBWOOFER
LIGHT-UP socket.
Caution:
< Assembling > < Attaching to the wall >
Wall Screws (not supplied)
Never mistake the FRONT SPEAKERS and the SUBWOOFER
terminals. The unit or the speakers may be damaged.
If you use other speakers with an impedance lower than that
specified, the unit may be damaged. Front speakers: 6 ohms,
Subwoofer: 12 ohms.
Do not mistake the right and the left
channels. The right speaker is the one on the
right side when you face the unit.
Do not let the bare speaker wires touch
each other.
Do not stand or sit on the speakers. You may
be injured.
Do not allow any objects to fall into or to be
placed in the bass reflex duct.
Incorrect
Red
Black
Purple
SUBWOOFER