Filter
Top Products
11
ENGLISH
10 Inch Long Throw Transducer 120 Watt Amplifier
VOLUME
010
+4 INPUT
-10 INPUT
POWER
ON
OFF
DESIGNED AND ENGINEERED IN THE UNITED STATES BY SAMSON TECHNOLOGIES
www.samsontech.com
CAUTION
S/N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W
POWER
RATING
MADE IN CHINA
ACTIVE MONITOR SPECS:
• 20Hz – 20kHz
• BIAMPED 50 WATT WOOFER
COPOLYMER CONE
• 20 WATT TITANIUM FERRO FLUID
TWEETER
• TIME ALIGNED WAVEGUIDE
• MAGNETICALLY SHIELDED
WARNING:
RESOLV MONITORS CAN ACHIEVE
EXTREMELY HIGH SOUND
PRESSURE LEVELS. USE CAUTION
OR HEARING DAMAGE MAY RESULT
10
-50
-30
-15
0
30
50
100
1K
10K30K
dBr
FREQUENCY RESPONSE FREQUENCY (Hz)
10
-27
-21
-15
-9
0
5
100
1K
10K30K
FREQUENCY (Hz)CROSSOVER
dBr
VOLUME
010
+4 INPUT
-10 INPUT
POWER
ON
OFF
DESIGNED AND ENGINEERED IN THE UNITED STATES BY SAMSON TECHNOLOGIES
www.samsontech.com
CAUTION
S/N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W
POWER
RATING
MADE IN CHINA
ACTIVE MONITOR SPECS:
• 20Hz – 20kHz
• BIAMPED 50 WATT WOOFER
COPOLYMER CONE
• 20 WATT TITANIUM FERRO FLUID
TWEETER
• TIME ALIGNED WAVEGUIDE
• MAGNETICALLY SHIELDED
WARNING:
RESOLV MONITORS CAN ACHIEVE
EXTREMELY HIGH SOUND
PRESSURE LEVELS. USE CAUTION
OR HEARING DAMAGE MAY RESULT
10
-50
-30
-15
0
30
50
100
1K
10K30K
dBr
FREQUENCY RESPONSE FREQUENCY (Hz)
10
-27
-21
-15
-9
0
5
100
1K
10K30K
FREQUENCY (Hz)CROSSOVER
dBr
FROM MIXER
R
L
Connecting to the Resolv120a Subwoofer
RESOLV 50a with Mono Sub
Adding a subwoofer (and extended low frequency response) to your RESOLV 50a system is easy using the
RESOLV 50a’s LINE LEVEL inputs. Below is a typical system set-up using the RESOLV 120a with a mixer and a
pair of RESOLV 50a satellite speakers. For a detailed wiring diagram, see the section “RESOLV 50a
Connections” on page 12. Follow the steps in the diagram below to set up your system:
• Lower your mixer’s master outputs to all the way off.
• Connect the mixer’s Left output to the RESOLV 120’s LEFT PREAMP LEVEL INPUT and the mixer’s
Right output to the RESOLV 120’s RIGHT PREAMP LEVEL INPUT. Now connect the RESOLV 120’s
LEFT PREAMP LEVEL OUTPUT to the input of the left RESOLV 50a, and the RESOLV 120’s RIGHT
PREAMP LEVEL OUTPUT to the input of the right RESOLV 50a.
• Run an audio signal (like some music from a CD) through your mixer and raise the level to a comfortable
listening level.
• Now adjust the SWEEP control to the desired frequency. A good place to start is about 70 Hz. You can
also use your ears by adjusting the SWEEP control to the frequency that sounds good to you.