Filter
Top Products
9
ENGLISH
Operating the RESOLV 50a
RESOLV 50a Control Panel
The RESOLV 50a’s rear control panel is where you will make your connections for both AC power and
audio signals. The rear panel also contains the controls to make adjustments to the overall volume and
frequency response curve. The following section details the rear panel controls and connections:
Powering the RESOLV 50a
Since the RESOLV 50a is an active studio monitor (with an on-board power amplifier and electronic crossover), it
is necesary to connect the unit to an AC power supply. Make sure that the main Power switch is set to the OFF
position and connect the supplied IEC power cable into the AC inlet.
Things that go Hum!
When running power cables, be careful not to run the AC power cords or AC extension cords in parallel
to your input cables. This will help reduce any AC hum that can be picked up. If your have to cross an
AC line with an audio line, try to cross them at a 90 degree angle for the least amount of induced hum.
Using the RESOLV 50a’s balanced input connectors will greatly protect against the induced hum
thanks to the common mode rejection
(the induced hum is phase canceled)
that its balanced input circuit provides.
POWER SWITCH – The POWER
switch is used to turn on the RESOLV
50a’s active electronics. When set to
the ON position, the blue, front panel
LED will illuminate indicating the unit is
powered up and ready for operation.
AC INLET - Connect the supplied
IEC power cable here.
VOLUME
010
+4 INPUT
-10 INPUT
POWER
ON
OFF
DESIGNED AND ENGINEERED IN THE UNITED STATES BY SAMSON TECHNOLOGIES
www.samsontech.com
CAUTION
S/N
RISK OF ELECTRIC SHOCK
DO NOT OPEN
115-230 vac ó 50Hz/60Hz 175W
POWER
RATING
MADE IN CHINA
ACTIVE MONITOR SPECS:
• 70Hz – 20kHz
• BIAMPED 50 WATT WOOFER
COPOLYMER CONE
• 20 WATT TITANIUM FERRO FLUID
TWEETER
• TIME ALIGNED WAVEGUIDE
• MAGNETICALLY SHIELDED
WARNING:
RESOLV MONITORS CAN ACHIEVE
EXTREMELY HIGH SOUND
PRESSURE LEVELS. USE CAUTION
OR HEARING DAMAGE MAY RESULT
10
-50
-30
-15
0
30
50
100
1K
10K 30K
dBr
FREQUENCY RESPONSE FREQUENCY (Hz)
10
-27
-21
-15
-9
0
5
100
1K
10K 30K
FREQUENCY (Hz)CROSSOVER
dBr
1
2
2
1