Filter
Top Products
Playing the Radio
PWR (Power): Push this knob to turn the system on
and off.
VOLUME: Turn this knob to increase or to decrease
the volume.
RCL (Recall): Press this button to display the current
radio station frequency. When the ignition is off,
press this button to display the time.
To change the default on the display, press the RCL
button until you see the display you want, then hold the
button until the display flashes. The selected display
will now be the default.
Finding a Station
AM/FM: Press this button to switch between FM1, FM2,
or AM. The display will show the selection.
TUNE: Turn this knob to select radio stations.
sSEEK t: Press the right or the left arrow to go to
the next or to the previous station and stay there.
The radio will only seek stations with a strong signal
that are in the selected band.
sSCAN t: Press and hold either SCAN arrow for
two seconds until SC appears on the display and
you hear a beep. The radio will go to a station, play for
a few seconds, then go on to the next station. Press
either SCAN arrow again to stop scanning.
To scan preset stations, press and hold either SCAN
arrow for more than four seconds. PRESET SCAN will
appear on the display and you will hear a double
beep. The radio will go to a preset station stored on the
pushbuttons, play for a few seconds, then go on to
the next preset station. Press either SCAN arrow again
to stop scanning presets.
The radio will only scan stations with a strong signal
that are in the selected band.
3-67