Filter
Top Products
Mains operation
1 Put the appliance plug in the parent unit and put the adapter into a wall socket.
The power-on light goes on.
Operation on non-rechargeable batteries
The parent unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Do not use rechargeable batteries, as the parent unit does not have a charging function.
Unplug the parent unit and make sure your hands and the unit are dry when you insert the non-
rechargeable batteries.
1 Press down the latch of the battery compartment lid and remove it (Fig. 4).
2 Insert four non-rechargeable batteries.
Note: Make sure the + and - poles point in the right direction.
3 Replace the lid on the battery compartment (Fig. 5).
Note: If the batteries are completely empty, the parent unit automatically switches off and loses contact
with the baby unit.
1
Set the on/off switch of both the baby unit and the parent unit to ‘on’ (Fig. 6).
2 Turn the volume control to switch on the parent unit and to set the volume to the level you
prefer. (Fig. 7)
3 Place the baby unit at least 1 metre/3 feet away from your baby.
4 Place the parent unit within the operating range of the baby unit. Make sure it is at least 1
metre/3 feet away from the baby unit. For more information on the operating range, see
section ‘Operating range’ below.
5 Set the baby unit and the parent unit to the same channel.
It takes 10 to 30 seconds before a connection is established.
The transmission frequency of channel A is 40.695 MHz.
The transmission frequency of channel B is 40.675 MHz.
6 The baby unit and parent unit are now connected.
Operating range
The operating range of the baby monitor is 150 metres/450 feet in open air. Depending on the
surroundings and other disturbing factors, this range may be smaller.
Dry materials Material thickness Loss of range
Wood, plaster, cardboard, glass
(without metal, wires or lead)
< 30cm/12in 0-10%
Brick, plywood < 30cm/12in 5-35%
Reinforced concrete < 30cm/12in 30-100%
Metal grids, bars < 1cm/0.4in 90-100%
Metal or aluminium sheets < 1cm/0.4in 90-100%
,
,
ENGLISH8