Filter
Top Products
Parent unit
Batteries
Only replace the non-rechargeable batteries of the parent unit with four 1.5V R6 AA batteries.
Note: We strongly advise you to use Philips non-rechargeable batteries.
Only replace the adapter of the parent unit with an adapter of the original type. You can order a
new adapter from your dealer or a Philips service centre:
SBC CS0920/00W (EU/SGP only)
SBC CS0920/05W (UK only)
9VD200 (AU/NZ only)
Do not throw away the appliance with the normal household waste at the end of its life, but
hand it in at an ofcial collection point for recycling. By doing this, you help to preserve the
environment (Fig. 9).
Batteries contain substances that may pollute the environment. Always remove the batteries
before discarding the appliance or handing it in at an ofcial collection point. Dispose of the
batteries at an ofcial collection point for batteries (Fig. 10).
If you need service or information or if you have a problem, please visit the Philips AVENT website
at or contact the Philips Consumer Care Centre in your country (you
can nd the phone number in the worldwide guarantee leaet). If there is no Consumer Care
Centre in your country, go to your local Philips dealer.
This chapter lists the questions most frequently asked about the appliance. If you cannot nd the
answer to your question, contact the Consumer Care Centre in your country.
Question Answer
Why can’t I establish a
connection?
The units may be set to different channels. Set both units to the same
channel and wait 10-30 seconds for the connection to be established.
The baby unit may be out of range of the parent unit or there may be
too many walls and/or ceilings between the two units. Try a different
location or reduce the distance between the two units.
Why is the connection
lost every now and
then?
The baby unit may be out of range of the parent unit or there may be
too many walls and/or ceilings between the two units. Try a different
location or reduce the distance between the two units.
Why do I hear noise
or a scratching sound?
There may be interference from another appliance or baby monitor.
Switch both units to another channel. Make sure both units are set to
the same channel.
The parent unit may be too close to a window, causing it to pick up
signals from other appliances or baby monitors. Move the unit away from
the window.
-
-
-
-
-
ENGLISH10