Filter
Top Products
The hood will come off, and the seat will fall.
15• To remove the hood, press the buttons on the
fasteners while lifting the hood.
REMOVABLE LINING
16• To remove the lining from the headrest, slip the
lining downwards, off the headrest frame and the
safety belt straps.
17• To remove the lining from the car seat, unscrew
the headrest frame, making sure to keep the
screws.
18• Slip the sack fasteners out from under the seat,
and slip the leg divider strap out.
INSTRUCTIONS FOR USE IN THE VEHICLE
IMPORTANT:
19• The Primo Viaggio SIP car seat is certified
for use with the Adjustable Base or without
it. Using the base in the vehicle guarantees
greater safety. We recommend using the child
seat in the vehicle without the base only as a
last resort.
• The Primo Viaggio SIP car seat can be fastened
to the front seat if the vehicle does not have
an airbag, or to the back seat. It is unsafe and
prohibited to fasten the child car seat using
two-point abdominal vehicle seat belts. Use
only a three-point seat belt to fasten the child
car seat, as shown in the figure.
FASTENING THE BASE TO THE VEHICLE
20• Place the base for the child car seat on the seat
of the vehicle. Since not all vehicle seats slope at
the same angle, the height-adjustable base will
allow you to keep the child car seat in the correct
position, parallel to the ground.
• The position of the base is correct when the
bubble on the gauge is completely visible.
• To adjust the base, use one hand to turn knob A,
and the other hand to push down on point B to
simulate the childs weight. Adjust the base so
that the bubble is completely visible in the gauge.
21• Slip the vehicle seat belt through the two side
slots on the base, as shown in the figure.
22• Fasten the buckle to the vehicle seat, as shown in
the figure.
23• If your vehicle is equipped with a seat belt with a
free-sliding buckle (like most modern vehicles),
you must attach a Surefix Clip to it. Using a
Surefix Clip guarantees correct attachment of the
child car seat to the base.
• Remove the Surefix Clip from its housing, as
shown in the figure.
24• Grab the vehicle shoulder strap (the free strap)
just above the buckle, and hold it taut while
slipping the Surefix Clip onto the free strap, as
shown in the figure. The Surefix Clip must hold
the strap taut. (Once the Surefix Clip has been
mounted correctly, it can be left on the vehicle
seat belt to make it easier to fasten the base each
time).
25• After mounting the Surefix Clip, check the tilt of
the base again. If the bubble is not completely
visible in the gauge, turn the knob again to
tighten the belt.
• The base is ready for fastening the child car seat
to it.
FASTENING THE CHILD CAR SEAT TO THE BASE IN
THE VEHICLE
26• Place your child in the child car seat, and fasten
the safety belt.
• The car seat must be positioned backwards, in
relation to the direction of the vehicle.
• Fasten the car seat to the base, pressing with
both hands until it clicks into place.
27• With the child car seat mounted in the vehicle, the
handle on the seat must be lowered all the way
against the back of the vehicle seat, as shown
in the figure. Push the handle until it clicks into
place.
28• Pass the vehicle seat belt around the backrest of
the child seat.
29• Slip the vehicle seat belt through the slot on the