Filter
Top Products
INSTRUCTIONS FOR USE
PRIMO VIAGGIO SIP with ADJUSTABLE BASE
Primo Viaggio SIP with Adjustable Base is the
child car seat certified for the 0+ age group, or
children weighing 0-13 kg. (0-12/14 months).
• Primo Viaggio SIP car seat has a Ganciomatic
System that allows you to remove it from “Peg
Perego” strollers or baby carriages with a flick of
the hand, and attach and detach it on its base in
the vehicle.
1• To detach the child car seat from its base, pull
the handle behind the backrest upwards with one
hand while lifting the seat with the other hand.
2• To attach the child car seat, line it up with the
hooks and push downwards with both hands until
the seat clicks into place.
SAFETY BELT
3• To fasten the safety belt, place one strap over the
other, and insert them into the buckle on the leg
divider, pressing until they click into place.
4• To unfasten the safety belt, press the red button
on the leg divider buckle.
5• The safety belt straps and the Side Impact
Protection headrest can be raised together to 5
different positions, to grow with the child.
• Before adjusting the height of the safety belt and
the headrest, release the tension on the straps.
• To adjust the height of the safety belt and the
headrest, press the height adjustor button
(located on the child seat backrest) while lifting
or lowering the headrest to the desired position,
making sure it clicks into place.
6• The correct position for the headrest is
determined by the correct position of the safety
belt straps. The childs shoulders should be just
above the point where the straps pass.
7• To release the tension in the safety belt straps,
slip your finger through the opening in the seat
and press the metal button while using your other
hand to pull the straps upwards, as shown in the
figure.
8• To fasten the straps with the child in the seat,
pull the central adjustment belt towards you, as
shown in the figure. Be careful not to pull the
straps too tightly against the child; leave just a
little play in the straps.
PADDING
9• To mount the shoulder padding, open the Velcro
fastener and place the padding on the safety belt
strap. Close the Velcro, with the opening turned
outwards.
10• To mount the leg padding, slip the leg divider
belt buckle through the padding, as shown in the
figure.
11• The car seat comes with a filler cushion for
newborn infants. Remove the filler after the child
has grown bigger. To remove the filler cushion,
slip it off the leg divider belt.
REGULATOR HANDLE
12• The car seat regulator handle has four positions.
To incline the seat, press the two buttons on the
handle and simultaneously adjust the seat until it
clicks into the desired position.
Position A: Set the handle to this position when
the child car seat is mounted in the car.
Position B: Set the handle to this position when
carrying the child car seat by hand or while
attaching it to its base, to a stroller, or to a baby
carriage.
Position C: Set the handle to this position to allow
the car seat to rock.
Position D: Set the handle to this position to
prevent the child car seat from rocking.
HOOD
13• To mount the hood, insert the fasteners into the
openings on the child car seat and arrange the
rear part of the hood behind the backrest.
14• To raise or lower the hood, push it backwards or
forwards.
• ATTENTION: Never grab the hood to lift the seat!