Filter
Top Products
PAGE 10 — B-SERIES TROWEL — PARTS & OPERATION MANUAL — REV. #1 (12/03/01)
Connect the throttle cable to the engine. Keep in mind there
should be a piece of wire installed on the machine to show you
where to route the throttle cable. When connecting the cable
housing, make sure that no more than 1/4" (6.4mm) of the cable
housing protrudes past the housing clamp on the engine (Step 4).
After the cable has been installed on the engine, tighten the clamp
on the throttle control, operator position of the handle to lock the
throttle cable at the proper length.
These are general instructions. Installation of the throttle cable
may vary for different engine configurations. Please look for more
detailed instructions inside the box containing the handle. These
more detailed instructions should provide adequate guidance for
installing.
General Instructions
Set the throttle lever to the idle position by pushing it away from
the operator’s position towards the engine (counter clockwise
from the top- Step 1). Loosen the screw that crimps the throttle
cable to allow free movement of throttle cable (Step 2).
On Robin engines, the hook on the engine end of the throttle wire
must be removed. Make the cut as shown (Step 3). The rest of the
engine will not require this modification to the throttle cable.
STEP 3STEP 3
STEP 3STEP 3
STEP 3
STEP 4STEP 4
STEP 4STEP 4
STEP 4
STEP 1STEP 1
STEP 1STEP 1
STEP 1
STEP 2STEP 2
STEP 2STEP 2
STEP 2
B-SERIES TROWEL — INSTRUCTIONS