Filter
Top Products
PAGE 18 — HTH44T • RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #8 (03/27/12)
)
1. The foot pedal (Figure 13) solely controls blade speed.
The position of the foot pedal determines the blade speed.
Slow blade speed is obtained by slightly depressing the
pedal. Maximum blade speed is obtained by fully
depressing the pedal.
Figure 13. Blade Speed Control Foot Pedal
HTH44T— INITIAL START-UP
7. Turn ignition key fully clockwise and listen for engine to
start. Once engine has started release ignition key. Let
engine warm for a few minutes.
8. Place the
engine
throttle lever
(Figure 10)
in the
HIGH
position.
Steering
Two joysticks (Figures 11 and 12) located to the left and right of
the operator’s seat provide directional control for the HTH44T
Ride-On Power Trowel. Table 3 illustrates the various directional
positions of the joysticks and their effect on the ride-on trowel.
Figure 10. Engine Throttle Control Lever (High)
9. The engine should be running at full RPM.
10. Repeat this section a few times to get fully acquainted
with the engine starting procedure.
All directional references with respect to
the joysticks are from the
operator’s
seat
position.
NOTE
Figure 11. Left Joystick Control
Figure 12. Right Joystick
gninoitisoPlanoitceriDkcitsyoJ.3elbaT
KCITSYOJ NOITCERID STLUSER
tfeL drawroFkcitsyoJevoM
edistfelehtylnosesuaC
otlewortno-edirehtfo
.drawrofevom
tfeL drawkcaBkcitsyoJevoM
edistfelehtylnosesuaC
otlewortno-edirehtfo
.drawkcabevom
thgiR drawroFkcitsyoJevoM
edisthgirehtylnosesuaC
otlewortno-edirehtfo
.drawrofevom
thgiR drawkcaBkcitsyoJevoM
edisthgirehtylnosesuaC
otlewortno-edirehtfo
.drawkcabevom
thgiRdnatfeL
htoBevoM
drawroFskcitsyoJ
lewortno-edirehtsesuaC
nidrawrofevomot
.enilthgiartsa
thgiRdnatfeL
htoBevoM
drawkcaBskcitsyoJ
lewortno-edirehtsesuaC
drawkcabevomot
.enilthgiartsani
thgiR thgiRkcitsyoJevoM
lewortno-edirehtsesuaC
.thgirehtotevomot
thgiR tfeLkcitsyoJevoM
lewortno-edirehtsesuaC
tfelehtotevomot