Filter
Top Products
PAGE 12 — HTH44T • RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #8 (03/27/12)
)
HTH44T— SPECIFICATIONS
NOTE:
1. This value includes the seat height.
2. Sound pressure is a weighted measure. Measured at the
operators ear position while the ride-on trowel is operating
at full throttle on concrete in a manner most often
experienced in “
normal
” circumstances. Sound pressure
may vary depending upon the condition of the concrete.
Hearing protection is always recommended.
3. The vibration level indicated is the maximum RMS (Root
Mean Square) value obtained at the handle grip while
operating the ride-on trowel on curing concrete in a
manner
most often experienced in “
normal
” circumstances.
Values were obtained from all three axes of motion. The
values shown represent the maximum RMS value from
these measurements.
4. “AW” stands for
anti-wear
and “MV” stands for
multi-
viscosity
. The 68 refers to the general viscosity range
and is similar to 10W-30-motor oil. It is recommended
that AW MV 68 hydraulic oil be used. If this type of
hydraulic oil is not available then use 10W-30.
Figure 1. HTH44T Dimension /Specifications
snoitacificepST44-HTH.2elbaT
)mc(.ni–htgneL–A )8.342(00.69
)mc(.ni–htdiW–B )721(0.05
)mc(.ni–thgieH–C
1
)241(0.65
gnitarepO).sgk(.sbl–thgieW )007(545,1
gnippihS).sgk(.sbl–thgieW )838(848,1
ABd–erusserPdnuoS
2
ABT
s/tf–noitarbiV
2
s/m(
2
)
3
ABT
)s/m(MPF–deepSpiTedalB )9.9(4291
.P.H–enignE 44
)sretil(snollag–knaTleuF )54(21
MPR–rotoR 061ot0
)mc(.ni–htdiWhtaP )332(29
liOciluardyH
4
86VMWA
enignE ET-5051VleseiDatobuK