Filter
Top Products
PAGE 20 — AR13HA/AR13HAR ROLLER (S/N 110301 & UP) • OPERATION AND PARTS MANUAL — REV. #0 (06/22/11)
INSPECTION
3. If the hydraulic oil level is low, remove the hydraulic
oil cap (Figure 14) and fill with type ISO 46 anti-wear
type hydraulic oil to the recommended operating level.
Figure 14. Hydraulic Oil Reservoir Filler Port
WATER TANK CHECK
1. To check the water tank water level, place the roller
on secure level ground.
2. The amount of water inside the water tank can be
visually inspected by reading the water tube (Figure
15) that runs vertically along the water tank at the rear
of the roller. This tube indicates the amount of water
inside the water tank. Total tank capacity is 40 gallons
(181 liters.)
Figure 15. Water Tank
REAR
ROLLER
WATER
TANK
WATER
TANK
CAP
WATER
LEVEL
TUBE
BATTERY CHECK
A 12-volt DC battery (Figure 16) is shipped dry, and will
require a proper electrolyte level for operation.
ALWAYS be sure that the battery cables are properly
connected to the battery terminals as shown below.
Generally the RED cable will be connected to the positive
terminal of the battery, and the BLACK cable will be
connected to the negative terminal of the battery.
Figure 16. Battery
NOTICE
If the battery cables are connected incorrectly, electrical
damage will occur causing damage to the roller's
electrical circuits. Pay close attention to the polarity of
the battery when connecting the battery.