Filter
Top Products
TROUBLESHOOTING GUIDE
TROUBLE LIKELY CAUSE REMEDY
Power LED not on Power not reaching unit Check mains connection
Check mains fuse
Check power switch is on
Distorted sound Output is being over driven Reduce output volume
No sound but amp is on Volume controls down Check volume controls
INTERNAL ADJUSTMENTS &
INSTALLATION / TROUBLESHOOTING
PAGE 7
AMIS ZONER16 INSTALLATION & OPERATION MANUAL
INPUT CONNECTIONS
For wiring balanced in, pin 2 is hot. Balanced input wiring (shielded pair cable) is recommended.
Unbalanced RCA wiring should be keep as short as possible. Typically less than 3m.
The only internal access required is for the installation of an Australian Monitor tone generator module. Installation is easy and is done by inserting the module
onto the appropriate headers.