Filter
Top Products
1155 Set vacuum regulator ring on
the cylinder to “Min”.
1166 Center breastshield(s) over
nipple(s). Switch on the
Lactina
®
Breastpump. Once
pumping begins, you may
adjust the vacuum to meet
your personal comfort level.
Important Note: If you experience discomfort, contact your
lactation professional as you may need a larger breastshield
or other lactation advice.
To locate a Breastfeeding Specialist in your area, call
1-800-TELL YOU.
If condensation appears in tubing:
To eliminate condensation after you have completed pump-
ing, continue running the pump with the tubing attached for
another 1-2 minutes or until dry.
If milk appears in tubing:
1. Turn off the pump and unplug from power source.
2. Remove and disassemble the tubing, pump connector,
piston and cylinder. Wash in soapy water then rinse in
cold clear water.
3. Shake waer droplets out of tubing and hang to air-dry.
For faster drying, attach tubing to pump and run pump
1-2 minutes or until dry, or pour a small amount of
isopropyl alcohol through the tubing to dry.
1100 Screw containers onto breast-
shield or use disposable
Collection Storage and
Freezing (CSF) Bags, article
#87010 or #87013 (sold
separately).
1111 Push ends of the tubing into
small round openings in the
backs of the breastshields.
(Location varies by breast-
shield used.)
1122 Grasp the yellow ends of the
tubing. Align and push into
each of the openings on the
pump connector.
1133 To double pump:
Turn the pumping ring to point
between the tubing.
The ring will also point to the
double pumping symbol.
1144 To single pump:
Turn the pumping ring to
point at the desired tubing.
The ring will also point to the
single pumping symbol.
1110