Filter
Top Products
45
206-4218
(Continued from previous page)
If the channel is set successfully, the system will display confirmation and then will search for
and identify the programs found for the specified channel, for example:
Channel: 7
Program selection (default):
Program 1: 1
Program 2: 2
Program 3: 3
Program 4: NC
Program 5: NC
Program 6: NC
Program 7: NC
Program 8: NC
After a tuner channel is set, programs are initially assigned to transport streams in numerical
order. If more than eight programs were found, the first eight will be assigned. You can edit
the program assignments as desired using the “prog” command described below.
Program Mapping
1. At the
Tuner Command >
prompt, type prog and press Enter.
The system displays the current program settings and then displays the rst of a series of
prompts for each input program, for example:
Current program selection:
Program 1: 1
Program 2: 2
Program 3: 3
Program 4: NC
Program 5: NC
Program 6: NC
Program 7: NC
Program 8: NC
Channel 7 programs: 1 2 3
Select input program 1 (use 0 for NC) [1]:
Note: Below the initial Current Program Selection list, the display identies the programs
that are available for the selected tuner/channel. More than eight programs may be
available; however, only eight may be selected.
Conguration Options via Command Line (Cont.)
(Continued on next page)