Filter
Top Products
LANIER – 1/3
rd
Scale Laser 200 ARF -INSTRU CTIONS
© 2002 Lanier R/CPage-12
75. Y ou will need to relieve more of the cow l,
depending on the muffler you decide to use.
76. Install the landing gear on the bottom of the fuse
with the included 4mm screw s and washers.
77. Position the gear fairing on the gear, then glue in
place with goop. Clam p in place until dry.
78. Locate the position of the axle hole in the w heel
pants using the 4” w heel as a guide.
79. M ark the size of the axle hole with the plyw ood
w heel pant plate, then drill with a drem el
grinding bit.
80. C enter the w heel pant plate inside the pant, then
fasten with 30 minute epoxy.
81. Secure the axle support plate on the opposite
side, keeping the w heel pant level.
82. Press the 4-40 blind nut into the plate using a
sm all clam p or large pliers.