Kawasaki B9272 Riding Toy User Manual


 
IMPORTANT! Use only a Power Wheels
®
12 volt battery
with built-in thermal fuse. Use of any other battery will
damage your vehicle. Make sure that you charge the battery
for at least 18 hours using the enclosed Power Wheels
®
12 volt charger before operating your vehicle for the first
time. Charge the battery for at least 14 hours after each
use of the vehicle. Never charge the battery longer than
30 hours. Failure to follow these instructions may damage
your battery and will void your warranty.
Press the tab under the back edge of the seat and lift to
remove the seat.
Lift the battery clamp to access the battery compartment.
Place the battery upright in the battery compartment.
Plug the motor harness connector into the battery. Push
firmly to join.
• Fit the tab at the front of the seat into the slot in the
vehicle near the handlebars.
“Snap” the tab at the back of the seat into the slot in
the rear of the vehicle.
Lift the battery clamp and slowly lower the battery into
the compartment.
Seat
Battery
Clamp
Battery Installation
H
12
1
4
3
2
11
1
11
2
Battery
Motor
Harness
Connector
Battery
Clamp