Kawasaki B9272 Riding Toy User Manual


 
Assembly
10
•Turn the vehicle upright.
Note: The left and right grips are not interchangeable!
The hole in the left grip is smaller than the hole in
the right grip.
• Fit the left grip on the end of the left handlebar.
• Fit the right grip on the end of the right handlebar.
Hint: If it is difficult to slide the grip onto the handlebar,
moisten the inside of the grip with water.
14
Fit the tab at the front of the seat into the slot in the
vehicle near the handlebars.
“Snap” the tab at the back of the seat into the slot near
the rear of the vehicle.
15
Seat
11
1
11
2
Left Grip
Small Hole
Right Grip
Large Hole
Fit a cap nut on the end of the front axle.
Fit the cap nut assembly tool over the cap nut. Tap the
end of the cap nut assembly tool with a hammer to
secure the cap nut on the end of the axle. Pull on the
front wheel to be sure it is secure.
Repeat steps 11 and 12 to assemble a washer, bushing,
front wheel, hubcap and cap nut to the other front axle.
13
Cap Nut
Cap Nut
Assembly
Tool
.437"
• Slide a washer onto a front axle.
Slide a bushing, ring end first, onto the front axle.
Slide a front wheel, flat side first, onto the front axle.
Slide a hubcap, indented side out, onto the front axle.
12
Front Axle
Bushing
(Ring End
First)
Front Wheel
(Flat Side
First)
Hubcap
(Indented
Side Out)
Washer