Filter
Top Products
Delta 1200 Technical Manual 07610-003-62-15 G
Issued: 10-27-2008 Revised:05-21-2012
SECTION 5: SERVICE PROCEDURES
WASH MOTOR REPLACEMENT (CONTINUED)
26
combination wrench.
6. With the nuts removed, grasp the motor assembly and lift up
on it to clear the mounting studs.
7. Turn the motor so that you will have access to the wiring
cover on the back. Be careful not to pull or yank too hard as
the motor is still connected to the unit by way of the power
lines.
8. Take the needlenose pliers and remove the power wires
from the terminals within the motor.
9. The motor should now be free. Replace with a new new
motor by performing the removal steps in reverse.
10. Place the disharge hose assembly back on the discharge
of the pump and tighten down.
11. Lift the assembly into place within the unit, ensuring that
the suction hose is attached and lines up. Move the assembly
so the mounting bracket slides over the mounting studs.
Suction hose coming off when moving the assembly.
Lifting up on the motor.
Pulling the discharge hose out.
Removing the assembly mounting nuts.
Loosening the discharge hose clamp.