Filter
Top Products
Delta 1200 Technical Manual 07610-003-62-15 G
Issued: 10-27-2008 Revised:05-21-2012
SECTION 5: SERVICE PROCEDURES
WASH TANK HEATER REPLACEMENT (CONTINUED)
21
5. Using the 3/8” nutdriver, remove the nuts securing the
heater wires to the heater. Then carefully pull the wires out of
the way.
6. Next, use the ratchet and 1/2” socket to remove the heater
mounting nuts.
7. Removing the heater may require that you reach into the
wash tank, grasp it and give it a push out of the wash tank.
8. Once the heater is pushed away from the tank wall, pull it
out with your hands.
9. Remove the old heater gasket and throw away.
10. Apply the new heater gasket.
11. Take the new heater and slide it through the hole in the
wash tank and line it up so the wash tank studs fit in the holes
on the heater flange.
12. Place the mounting nuts and lockwashers on the studs and
secure them with the ratchet and 1/2” socket.
13. Place the heater wires on the heater and tighten them
down using the 3/8” nutdriver.
Removing upper (wash) strainer.
Reaching into the wash tank.
Pulling the heater out.
Removing the heater nuts.
Using the ratchet to remove the heater mounting nuts.