Filter
Top Products
WorkPad z50 Mobile Companion 17
Installing the ROM/DRAM Card
This section describes how to install the ROM card or the
optional DRAM card to the WorkPad z50.
Note: When you remove the ROM/DRAM card, you will lose
all stored data. Before you remove the ROM/DRAM card, be
sure to back up all data and applications in the base
memory.
Caution: Before removing or inserting the ROM/DRAM card,
all power sources (AC power, the main battery pack, and the
backup batteries) must be removed.
Follow these instructions when inserting the ROM/DRAM
card:
1. Place the WorkPad z50 into suspend mode and
disconnect AC power.
2. Turn the WorkPad z50 upside down.
3. Remove the main battery and remove the backup
batteries.
4. Unscrew the single (captive) screw that secures the
ROM/DRAM card compartment cover to the chassis.
Remove the cover.
Unscrew the screw
that secures the
ROM/DRAM card cover
to the chassis and
remove the ROM/DRAM
card cover.
ROM card
DRAM card
5. Locate the ROM/DRAM card Slot.
6. Find the notch on the side of the card.
20