Harbor Freight Tools 92906 Doll User Manual


 
SKU 92906 For technical questions, please call 1-800-444-3353. Page 8
Figure 8
Right
Wing (1b)
Fuselage
(3)
Safety
Button
ON/OFF
Switch
2. Switch the Remote Control (11) “ON” and the plane “ON”. Lastly, press the Safety Button on
the side of the Fuselage (3) under the Right
Wing (1b) - see Figure 8.
3. Face the Airplane into the wind. Move the Plane
Speed Control all the way up so that the motor
is running at full power.
Note: If launching from a Rolling Take - off make
sure Plane taxies straight, if not adjust
Wheel Wires by bending one or both to
achieve a controlled straight taxi.
4. With Airplane at FULL POWER and taxiing in
a straight line pull back on the Elevator Control
to gain altitude and achieve Take - off.
Note: If Hand Lauching it is recommended two people work together to launch the Plane, one to
Launch and one to operate the Radio Transmitter.
5. If Hand Launching tilt the Plane up about 10°, propel in a straight line and release into the
wind.
6. Let the Airplane climb to and fly at about 50 to 300 feet high. By moving the control sticks you
can change pitch, direction, and speed.
7. If the Airplane rises too slowly, or dives, you may wish to adjust the elevator trim until the plane
flies level with no pressure applied to the stick.
8. To steer the Airplane, move the rudder control stick to the left to steer to the left, and right to
steer it right. Move the rudder control stick slightly to adjust for minor changes in direction and
tilt of the Airplane.
9. If the airplane drifts to the right or left, you may adjust the rudder trim accordingly.
If the Airplane continues to fly too far right or too far left, correct for it by moving the rudder
control the opposite direction. If flying left, move the control right. If flying right, move the
control left.
If adjusting the rudder control does not work, land the Airplane and adjust the Rudder Pushrod
(4) to compensate.
10. Note that letting go of the control sticks will automatically bring them to a center position. This
will cause the Airplane to glide, unpowered.
11. Normal flight time for one full charge is about ten (10) minutes. If the plane appears to be losing
power or climbs with difficulty, the batteries are low. Land the plane.
12. When the remote control’s battery begins to reach the end of its power, the red indicator light will
blink or it will make a warning noise. When this occurs, IMMEDIATELY LAND THE AIRPLANE.
If the remote control’s battery is allowed to die completely, the plane will be uncontrolled
and may cause damage to property or SEVERE PERSONAL INJURY.
13. To bring in the Airplane for landing, glide the Airplane down against the wind. Move the
plane speed control backwards to slow the Propeller (9). Pull the Elevator control stick back
somewhat to pull the nose of the plane up. Move the rudder control stick to adjust for direction.
Continue to gradually decrease the Propeller (9) speed until you bring it to a stop and land the
Airplane. If airplane descends too quickly, press slightly harder on the plane speed control to
compensate.
REV 08j