Filter
Top Products
50
1. Install child restraint and tighten vehicle seat belt.
2. Hold seat belts together at latch plate (a) then unbuckle.
3. If a locking clip is needed (see Pg. 49 “Locking Clip” section),
slide locking clip on seat belts appoximately 1 inch (2.5 cm)
away from latch plate.
4. Re-buckle seat belt.
5. Test installation to see if child restraint is secure.
If not secure, additional belt tightening may be required:
• Unbuckle vehicle seat belt.
• Hold belts together and remove locking clip.
• Shorten length of lap belt portion
slightly by pulling belt through latch plate
• Re-attach locking clip.
• Buckle vehicle seat belt.
Press child restraint further down into vehicle seat
cushion to help buckle vehicle seat belt.
Test installation to see if child restraint is secure. If not secure,
repeat above step until secure.
within 1”
(2.5 cm)
a
VEHICLE SEAT BELTS
(continued)