Filter
Top Products
20
REAR-FACING INSTALLATION WITH LATCH
1. Recline fl ip foot must be in
REAR-FACING position (a). (If it is
not, see page 36, Recline Flip Foot.)
2. LATCH belt must be routed through
the opening in child restraint marked
as REAR-FACING with a BLUE label
(b). (If it is not, see page 40, LATCH
Belt Routing For Rear-Facing Mode.)
3. Place rear-facing on vehicle seat
equipped with LATCH anchors. For
ease of installation, extend LATCH
belt to its maximum length.
4. Attach LATCH connectors to
vehicle lower anchors (c). Belt must
lie fl at and not be twisted. Pull
connectors to be sure they are
securely attached to the anchor
points. (d).
5. Press down fi rmly in center of child
restraint while pulling on the tail of
the LATCH belt to tighten (e).
a
b
d
e
c
CLICK!