Graco PD106974A Car Seat User Manual


  Open as PDF
of 96
 
REAR-FACING INSTALLATION WITH VEHICLE SEAT BELTS
16
1
6
5
4
3
2
Store LATCH belt by attaching to connectors
through forward-facing openings
(see page 31, fig. k
s!TTACHCONNECTORSTOSTORAGEBARONEACH
side (fig. a).
s!DJUST
LATCHBELTTOREMOVEEXCESSSLACK
by pulling adjustment belt.
Adjust car seat to recline position
(see fig. b and page 25, fig. g
Place
rear-facingONVEHICLESEAT
4HREADVEHICLESEATBELTTHROUGHOPENINGSAND
BUCKLEBELT
0RESSDOWNlRMLYINCENTEROFCHILDRESTRAINTTO
COMPRESSVEHICLESEATCUSHIONWHILETIGHTENING
VEHICLESEATBELT(fig. c).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. d)4HE
CHILDRESTRAINTSHOULDNOTMOVESIDETOSIDEOR
FORWARDMORETHANINCHCM6EHICLELAP
belt MUST stay tight.
If not secure, see “Vehicle Seat Belts” page 32.
#HECKLEVELINDICATORONCHILDRESTRAINT
Vehicle mustBEONLEVELGROUNDANDCHILDIN
CHILDRESTRAINTWHENCHECKINGLEVELINDICATOR
Ball MUST be entirely in green zone (fig. e).
If necessary, place rolled towels under child
RESTRAINTATVEHICLESEATCREASEUNTILENTIREBALL
ISINGREENZONE4HENRECHECKLEVELINDICATOR
DO NOT use tether
rear-facing4ETHERmust
BESTOREDSEEh4ETHER3TORAGEvPAGE
0ERFORMTHISTESTEVERYTIMEYOUDRIVEWITHYOUR
child.
WARNING
LATCH belt MUST be stored when
using vehicle seat belt to install
child restraint.
 previous next