Graco PD106974A Car Seat User Manual


  Open as PDF
of 96
 
REAR-FACING INSTALLATION WITH LATCH
12
1
7
6
5
4
3
2
LATCH belt must be routed through opening in
child restraint for
rear-facing mode.
(see page 29, fig. d
Belt must lay flat and not be twisted.
Adjust child restraint to recline position
(see fig. a and page 25, fig. g0LACE
rear-facingONVEHICLESEATEQUIPPEDWITH
LATCH anchors.
For ease of installation, extend
LATCH belt to its
maximum length.
(OOKCONNECTORSTOVEHICLELOWERANCHORS
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. c).
0RESSDOWNlRMLYINCENTEROFCHILDRESTRAINT
while pulling
LATCH adjustment belt. (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e)4HE
CHILDRESTRAINTSHOULDNOTMOVESIDETOSIDEOR
FORWARDMORETHANINCHCM
#HECKTHATTHELOWERANCHORAGEBELTSTAYS
tight and does not slip from the tightened
position. If it does not stay tight, try another
SEATINGPOSITIONORCONTACT#USTOMER3ERVICE
#HECKLEVELINDICATORONCHILDRESTRAINT
Vehicle mustBEONLEVELGROUNDANDCHILDIN
CHILDRESTRAINTWHENCHECKINGLEVELINDICATOR
Ball MUST be entirely in green zone (fig. f). If
necessary, place rolled towels under child
RESTRAINTATVEHICLESEATCREASEUNTILENTIREBALL
ISINGREENZONE4HENRECHECKLEVELINDICATOR
DO NOT use tether
rear-facing4ETHERmust
BESTOREDSEEh4ETHER3TORAGEvPAGE
0ERFORMTHISTESTEVERYTIMEYOUDRIVEWITHYOUR
child.
 previous next