Graco PD106974A Car Seat User Manual


  Open as PDF
of 96
 
FORWARD-FACING INSTALLATION WITH LATCH
14
1
7
6
5
4
3
2
LATCH belt must be routed through
opening in child restraint for
forward-facing
(see page 29, fig. e
Belt must lay flat and not be twisted.
Adjust car seat to upright position (see fig. a
and page 25, fig. g3ECURERECLINE
STANDINTO5PRIGHT0OSITIONBYPUSHINGTABS
INTOLOCKPOSITION
Place
forward-facingONVEHICLESEATEQUIPPED
with
LATCH anchors.
For ease of installation, extend
LATCH belt
to its maximum length.
(OOKCONNECTORSTOVEHICLELOWERANCHORS
(fig. b). Pull connectors to be sure they are
securely attached (fig. c).
3LIDECHILDRESTRAINTBACKUNTILTHECHILDRESTRAINT
ISINCONTACTWITHTHEVEHICLESEATBACK
0RESSDOWNlRMLYINCENTEROFCHILDRESTRAINTTO
COMPRESSVEHICLESEATCUSHIONWHILETIGHTENING
LATCH belt by pulling adjustment belt.
5SEYOURKNEETOPRESSDOWNINCENTEROF
child restraint (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e)4HE
CHILDRESTRAINTSHOULDNOTMOVESIDETOSIDEOR
FORWARDMORETHANINCHCM
#HECKTHATTHELOWERANCHORAGEBELTSTAYS
tight and does not slip from the tightened
position. If it does not stay tight, try another
SEATINGPOSITIONORCONTACT#USTOMER3ERVICE
!TTACHTETHERSTRAPHOOK(A) to anchor
hardware (B) and tighten adjustment belt to
REMOVEANYSLACK(fig. f).
Belt must lay flat and not be twisted.
0ERFORMTHISTESTEVERYTIMEYOUDRIVEWITHYOUR
child.
8
 previous next