Filter
Top Products
30
1. For ease of installation, extend UAS
to its maximum length.
2. Position base in vehicle seat as
shown.
3. Thread UAS through base belt
path normally used for vehicle seat
belt. Make sure that UAS is under
tongue on base ➊.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached ➋.
5. Tighten UAS by pushing down
hard on base and pulling the
adjustment belt ➌.
6. NEVER put two UAS connectors on
one vehicle UAS anchor unless
specifically allowed by the vehicle
manufacturer ➍.
7. Test infant restraint for secure
installation as described in infant
restraint “Final Safety Check” p.33.
8. Check that the UAS stays tight and does
not slip from the tightened position.
If it does not stay tight, try another seating
position or contact Customer Service.
6.4 Using UAS to install Base
Tongue
➊
➋
➌
➍