Filter
Top Products
21
• Combination Lap/Shoulder
Belt with Sliding Latch Plate
This belt has a latchplate that
slides freely along the belt.
This belt MUST be converted to prevent
movement of the lap portion of the belt. You
must use the locking clip provided with the
infant restraint, unless your vehicle's seat belt
can be converted in another way as described
in your vehicle owner's manual.
To Install Locking Clip:
1. Tighten the buckled belt by pushing
down hard on the infant restraint and
pulling hard on the shoulder belt.
2. While pushing down on infant restraint,
pinch the two straps together behind
the buckle tongue. Unbuckle the belt
without allowing it to slip.
3. Connect lap and shoulder belts
with locking clip as shown ➊ and
➋.
4. Rebuckle belt. Check that lap belt
does not move by pulling and
pushing hard
on infant restraint. If belt
loosens or lengthens,
repeat procedure.
Locking clip
1 cm
(½inch)
➊
Locking clip goes here,
1cm (½ inch) from the buckle
➋