Setup
16 311511G
Step Two - Reposition Power Jumpers
Find location of Power Jumpers.
For 230V, 1 Phase and 230V, 3 Phase Installations,
change jumper positions as shown below. Machine is
shipped with jumpers in the fail-safe 380 3Ø position.
1. Remove upper rear control cover screws and cover.
2. Move one red jumper from the storage positions to
the positions shown for your power.
• A flat-blade screwdriver can be used under the
ridge on the side of the jumper to remove them.
• Push the jumper firmly into the new position.
3. Replace rear cover and two screws.
Power Jumper
Location
ti8609a
, , , .
6
, , , .
6$ELTA
, , , .
679%
Step Two
TB2
Terminal Blocks
Position red jumpers
(under back cover on
opposite side)
ti8610a
(as shipped)